Beckhoff AX8000

Diagmessages of module DeviceMain
Multi axis servo system - AX8000 95
Version: 1.1
4.13 8782, Configured Sync1 Cycle Time is not a multiple of
the Sync0 Cycle Time
The configured Sync1 Cycle Time is not a multiple of the Sync0 Cycle Time.
Diagnostic Code (Hex.) Diagnostic Code (Dez.)
8782 34690
Class Type
Error Error
Standard Reaction Reset
Axis is inoperable Execute Reset-Command (Fault reset).
Possible Causes Solutions
The Cycle Time of your NC-Task has to be a multiple
of the drives Sync0 Cycle Time.
Please set your Task to a valid Cycle Time.
Internal: 0x8782, Sync Controller: Configured Sync1 Cycle Time (%u ns) is not a multiple of the Sync0 Cycle
Time (%u ns).