Power On Setup Functions Power On Setup
116
Qlarity-Based Terminal Hardware
Press [Next] or [Back] to move to the DONE section, and select Save and Exit to exit Power
On Setup.
8.4.9.2 Rpt Rate
Use this function to select the time that you want between each repeat when a key begins to
repeat automatically.
Press
[Next] to move to Rpt Rate, and press [Select] to move to the options. Press [Next] or
[Back] to select the key repeat rate. The choices range from 2.0 to 30.0 characters per second
(cps). The default is 6 cps. Press
[Select] to return to the function name.
Press
[Next] or [Back] to move to the DONE section, and select Save and Exit to exit Power
On Setup.
8.4.10Sound
This section only appears if the audio decoder option has been installed.
8.4.10.1Volume
Set the master volume of the speaker. This affects volume of sounds played by the PlaySound
API as well as that of the PlayNote API. (Exception: on QTERM-G55 terminals, only the
PlayNote API is affected by the volume setting.)
Press
[Next] or [Back] to move to SOUND. Press [Select] and then press [Select] again to
move to the
Volume setting. Press [Next] or [Back] until the volume is at the desired level. A
tone will be played with each press to indicate the current volume.
8.4.10.2Note Amplitude
Set the volume of beeps played by calls to PlayNote on units that include the optional audio
decoder.
Press
[Next] or [Back] to move to SOUND. Press [Select] and then press [Next] again to move
to the
Note Amp setting. Press [Select] again to start setting the note amplitude. Press [Next]
or
[Back] until the volume is at the desired level. A tone will be played with each press to indi-
cate the current volume.
8.4.11Feedback
The feedback functionality controls how the unit reports development information and fatal
errors. Any combination of COM1, Display, USB, and UDP ( Ethernet, if available) can be
selected.
To Next Page
Loading...
Need help?
General
