Beijer Electronics QTERM-G70 User Manual

Power On Setup Power On Setup Functions
Qlarity-Based Terminal Hardware 117
8.4.11.1Serial
Use this function to enable or disable feedback to the primary serial (COM1) interface.
Press
[Select] and [Next] to move to Serial, and press [Select] again to move to the options.
Press
[Next] or [Back] to select On or Off, then press [Select] to return to the function name.
Press
[Next] or [Back] to move to the DONE section, and select Save and Exit to exit Power
On Setup.
8.4.11.2Video
Use this function to enable or disable feedback to the display.
Press
[Select] and [Next] to move to Video, and press [Select] again to move to the options.
Press
[Next] or [Back] to select On or Off, then press [Select] to return to the function name.
Press
[Next] or [Back] to move to the DONE section, and select Save and Exit to exit Power
On Setup.
8.4.11.3USB
Use this function to enable or disable feedback to the USB device communications interface.
Press
[Select] and [Next] to move to USB, and press [Select] again to move to the options.
Press
[Next] or [Back] to select On or Off, then press [Select] to return to the function name.
N
OTE
☞
Feedback via the USB device communications interface requires installation of the Beijer
Electronics USB Communications drivers and a PC host application to gather and display the
feedback. Contact Beijer Electronics Technical Support for additional details.
Press
[Next] or [Back] to move to the DONE section, and select Save and Exit to exit Power
On Setup.
8.4.11.4UDP
Use this function to enable or disable feedback to the network interface via the UDP protocol.
If this option is enabled, you should also set the desired IP address and port number to receive
the feedback (see Addr and Port Number below).
Press
[Select] and [Next] to move to UDP, and press [Select] again to move to the options.
Press
[Next] or [Back] to select On or Off, then press [Select] to return to the function name.
Press
[Next] or [Back] to move to the DONE section, and select Save and Exit to exit Power
On Setup.

Beijer Electronics QTERM-G70 Specifications

General

Brand	Beijer Electronics
Model	QTERM-G70
Category	Touch terminals
Language	English