Beijer Electronics QTERM-G70 - E-Stop Option with Integral Cable; Network Interface with Integral Cable (with Ethernet Option); Serial Interface with E-Stop Option and Integral Cable; Tion)

Supported Interfaces QTERM-G56 Terminal
56
Qlarity-Based Terminal Hardware
4.2.2.4 Network Interface with Integral Cable (with Ethernet option)
The following table shows the pinout for the 10/100Base-T network interface.
4.2.2.5 E-stop Option with Integral Cable
If the terminal is equipped with the E-stop option (which requires the integral cable), the
DB15f pinout changes to accommodate the switch signals, as shown below.
4.2.2.6 Power and USB Device Interfaces with E-stop Option and Integral Cable
The following table shows the pinout for the power and USB device interfaces when the
E-stop option and integral cable are selected.
4.2.2.7 Serial Interface with E-Stop Option and Integral Cable (without Ethernet option)
The following table shows the pinout for the selected typed of serial interface on the multipro-
tocol port with integral cable and E-stop option.
DB15f Pin Ethernet
7Tx+
14 Tx-
6Rx+
13 Rx-
DB15f Pin Regulated (standard) 5 Volt USB Host
9 8 - 32 VDC 4.5 - 5.5 VDC
1 Ground Ground
2 N/A USB D+
3 N/A USB D-
DB15f EIA-232 EIA-422 EIA-485
4TxTx-Rtx-
14 RTS (out) Tx+ Rtx+
10 Rx Rx+ No connect
13 CTS (in) Rx- No connect