Power On Setup Power On Setup Functions
Qlarity-Based Terminal Hardware 111
Auth: Open | SharedKey | WPA PSK | WPA None | WPA2 PSK
This item selects the 802.11 authentication scheme. Press
[Select] with “Auth” highlighted to
begin selection. Press
[Next] and [Back] until the desired scheme is displayed. Press [Select]
to complete selection.
Encryp: None | WEP128 | TKIP | AES
This item selects the 802.11 encryption algorithm. Press
[Select] with “Encryp” highlighted to
begin selection. Press
[Next] and [Back] until the desired algorithm is displayed. Press
[Select] to complete selection.
WEP Key: 1-4
If WEP encryption is selected, this item allows selection of the WEP key to use for 802.11
communications. The terminal supports up to 4 keys. Press
[Select] with “WEP Key” high-
lighted to begin selection. Press
[Next] and [Back] until the desired key number is displayed.
Press
[Select] to complete selection.
WEP Key 1 through WEP Key 4:
If WEP encryption is selected, these items are used to set the contents of the WEP Keys. Press
[Select] with the desired “WEP Key #” highlighted to begin key setting. The key entry field
will be displayed. The keys must be set in hexadecimal format. Press
[Next] and [Back] until
the desired hexadecimal digit is displayed. Press
[Select] to accept that digit and move to the
next. Unused digits at the end of the key should be set to 0. Entry will automatically terminate
after the last digit has been set.
WPA Key:
If WPA (TKIP or AES) encryption is selected, this item is used to set the contents of the WPA
Key. Press
[Select] with “WPA Key” highlighted to begin setting the key. The key entry field
will be displayed. The keys must be set in hexadecimal format. Press
[Next] and [Back] until
the desired hexadecimal digit is displayed. Press
[Select] to accept that digit and move to the
next. Unused digits at the end of the key should be set to 0. Entry will automatically terminate
after the last digit has been set.
N
OTE
☞
Key lengths must be at least 8 characters (16 hexadecimal digits). WPA keys may be up to 32
characters in length, but the Power On Setup utility only supports setting of 8-16 character
keys (up to 32 hexadecimal digits). Longer keys must be set by the application.
8.4.7 COM1 and Any Additional Installed Serial Ports
NOTE
☞
If you have an optional secondary serial port, you will also see the “COM2” category. You
should configure both COM1 and COM2 as described in this section.
Some custom terminals may be configured with up to 10 serial ports. On these units, sections
for COM1 through COM10 will appear in the menu. All serial ports are configured in a similar
manner.
Use the following functions to configure your serial communications port(s).
To Next Page
Loading...
Need help?
General
