Powering On the Terminal for the First Time QTERM-G56 Terminal
62
Qlarity-Based Terminal Hardware
• Select the application mode
• Set up communications settings for the terminal
• Adjust display backlight
• Enter network (Ethernet) settings
• Enter/change password (if used)
• Set the real-time clock
• Set speaker volume
• Adjust settings for the keypad and keypad backlight (if available)
4.4.1 Accessing The Internal Mass Storage Via USB
The QTERM-G56 includes internal NAND flash for mass storage. This storage memory is
accessible from both the application and the USB device interface, where it appears as a
FAT-formatted file system to the USB host.
To access the internal mass storage via USB, connect the terminal to a PC or other USB host
using the QTERM-G56 Programming Cable accessory. The USB host will enumerate the ter-
minal, which should appear as a removable disk mounted to the host’s file system. The file sys-
tem may take several seconds to become available for viewing or modification. Files may be
stored or retrieved using file access software on the PC, as with any USB mass storage device.
Note that many operating systems recommend or require that a USB removable disk be ejected
before it is removed. See the documentation for your PC operating system for more details.
To Next Page
Loading...
Need help?
General
