Beissbarth MT ZERO 6 LCD - Product Description; Intended Use; Prerequisites; Scope of Delivery

1 695 600 968 2019-01-28| Beissbarth GmbH
74 | MT ZERO 6 LCD | Product description
3.2 Prerequisites
The MT ZERO 6 LCD must be installed on a flat surface
made of concrete or similar material and anchored in
position.
! An uneven or vibrating surface can lead to
inaccurate imbalance measurements.
! Any non-contiguous floor covering or deviation from
the above-mentioned safety requirements releases
the manufacturer from all liability for damage to
objects and/or personal injury.
3. Product description
3.1 Intended use
The MT ZERO 6 LCD is a wheel balancing machine
with mechanical (MT ZERO 6 LCD AWx) or pneumatic
(MT ZERO 6 LCD AWxP) wheel clamping. The
MT ZERO 6 LCD can be used to balance passenger
car, small van and motorcycle wheels with a rim
diameter between 10'' - 30'' and a rim width between
1'' - 15''
1)
.
The MT ZERO 6 LCD is to be used exclusively for
this purpose and solely for the range of applications
specified in these instructions. Any other purpose is not
consistent with the intended use and is therefore not
permissible.
i The manufacturer does not accept any liability for
possible damage arising from improper use.
!
1)
* These dimensions refer to standard rims (A);
for rims with a special shape (B - C), special
accessories should be used.
A
B
C
Fig. 2: Rim types
¶ Do not use the laser equipment in areas exposed to
explosion hazards or environments with flammable
liquids, gases or dust.
Sparks may form in the laser equipment and ignite
dust or vapors.
¶ Protect the laser equipment from warmth as well as
continuous solar irradiation, fire, water and moisture.
Explosion hazard.
en
3.3 Scope of delivery
3.3.1 MT ZERO 6 LCD
651127-04_BM
4
1
7
2
3
5
6
Denomination Order
number
Qty.
1 Wheel guard 1 695 600 809 1
2 Wheel guard moving unit - 1
3 Mechanical quick-action clamp
parts set
1)
1 695 602 400 1
3* Mechanical quick-action clamp
(NA) parts set
1)
1 695 655 837 1
3** Parts set, pneumatic quick-action
clamp
1)
1 695 655 602 1
3*** Pneumatic quick-action clamp
parts set, L = 130mm
1)
1 695 601 006 1
4 Support frame with sonar - 1
5 Digital control panel - 1
6 Holder for digital control panel - 1
7 Equipment - 1
Operating instructions 1 695 600 968 1
Instructions for tire service devices 1 695 000 006 1
¹
)
May be included in the scope of delivery depending on the version
ordered