Beissbarth MT ZERO 6 LCD - 11. Faults

1 695 600 968 2019-01-28| Beissbarth GmbH
116 | MT ZERO 6 LCD | Faults
11. Faults
i Other possible malfunctions are primarily of a technical nature and are to be checked and if necessary rectified
by a qualified engineer. Always contact the customer service of your authorized Beissbarth equipment dealer.
i For rapid assistance, it is important to provide the information on the rating plate (label on MT ZERO 6 LCD)
and describe the nature of the problem when calling.
Err Possible causes Remedy
The displays do not light up when power is switched on. Check the power connector.
If the error message persists, contact customer service.
Caution: Repeated fuse damage is an indication of a
malfunction!
Err 1 R Setting and calibration data lost from circuit board
memory.
R One or more calibration operations (setting, calibration
of electronic rim-distance gauge/rim-width gauge) not
performed.
Check and correct calibration and settings.
Err 2 Wheel-guard hood raised prior to completion of
measurement.
Wait for end of measurement before raising wheel-guard
hood.
Err 3 Wheel rotates backwards on start of measurement. Check that wheel is stationary when starting and stop it
from turning backwards on starting.
If the error message persists, contact customer service.
Err 4 R No motor operation. The motor is not reaching the
required speed.
R Fault in electrical connection.
R Check the voltage (probably too low).
R Check the electrical connection or power supply
cable.
If the error message persists, contact customer service.
Err 5 Balance weight not attached to wheel. Repeat calibration from the start and attach balance
weight as specified by the process (see "Calibration").
If the error message persists, contact customer service.
Err 6 Wheel-guard hood not lowered. Lower wheel-guard hood with wheel attached.
If the error message persists, contact customer service.
Err 7 Excessive phase difference between the 2 measurement
sensors.
R Check for correct attachment of calibration weight ;
R Check machine connection; probably not
MT ZERO 6 LCD stabile and vibrating excessively;
If the error message persists, contact customer service.
Err 8 No signal from measurement sensor. Inform customer service.
Err 9 No signal from external sensor. Inform customer service.
Err 10 R No motor operation.
R Wrong signal from measurement sensor for sensing the
position.
Check the power connector.
Inform customer service.
Err 11 R No motor operation.
R Wrong signal from sensor for sensing the phase.
Check the power connector.
Inform customer service.
Err 17 Weight outside setting range (weight required for balancing
is more than 250g).
R Check whether the wheel is correctly attached to the
flange.
R Determine the outer weight position (in any case),
attach a 100g weight and start another measurement.
Err 18 Rim data not entered. Enter rim data before performing measurement.
Err 19 Input signal of right measurement sensor lower than that of
left sensor.
If the error message persists, contact customer service.
Err 20 R Pedal pressed during measurement.
R Irregular rotational speed of motor.
R Wheel speed below minimum value
R Do not press pedal while motor is in operation:
R Make sure the MT ZERO 6 LCD is not subjected to
any impact during measurement.
R Check the voltage (probably too low).
Err 21 Circuit board has detected excessively high wheel rotational
speed with wheel-guard hood open (shat rotating at high
speed without the machine having been started): Power
supply unit deactivated.
R Switch off the MT ZERO 6 LCD.
R Lower wheel-guard cover, switch the
MT ZERO 6 LCD on again without moving the wheel.
If the error message persists, contact customer service.
Err 22 Irregular measurement sensor signals. If the error message persists, contact customer service.
en