Beissbarth MT ZERO 6 LCD - Attaching the Clip-On Balance Weights

1 695 600 968 2019-01-28| Beissbarth GmbH
108 | MT ZERO 6 LCD | Operation
7. Attach the adhesive balance weight of the correct
value using the electronic rim-distance gauge.
 Attach the balance weight behind the second
spoke.
i For attaching adhesive balance weights, see the
"Attaching adhesive balance weights" section.
i For attaching adhesive balance weights using
the integrated laser indicator, see the "Attaching
adhesive balance weights by laser indicator"
section. The laser indicator will only be active if the
attachment of the balance weight by electronic rim-
distance gauge is deactivated.
i To close the "SPLIT" program and return to the
display of just one balance weight, press the
<SPLIT> key again.
i After the balance weights have been attached, the
imbalance must be measured again to check the
balance.
8.12 Attaching the clip-on balance weights
The clip-on balance weights are shown on the screen as
explained below.
1
2
Fig. 84: Display of the clip-on balance weights
1 Weight on the inside of the rim (facing toward the wheel
balancing machine)
2 Weight on the outside of the rim (facing toward the outside)
i Use the balance weight pliers to position the clip-on
balance weights.
Fig. 85: Balance weight holder
1 Tip to remove the clip-on balance weight
2 Hammer for attaching the balance weight to the rim
3 Shears for trimming the adhesive balance weights
4 Recess for pressing in the clip-on balance weight
5 Blade for scraping off the adhesive balance weights
1. As soon as the exact position for attaching the
balance weight is reached, place the adhesive
balance weight on the edge of the rim.
2. Attach the clip-on balance weight to the rim using
the hammer end of the balance weight pliers (2).
Fig. 86: Attaching a clip-on balance weight
i Use the tip (1) of the balance weight pliers to
remove the adhesive balance weight.
en