BinTec RS120 - Page 158

Field Description
• All possible values for the Port Usage and the ISDN Config-
uration Type.
• A#: Detection is still running.
Port Usage Only if Autoconfiguration on Bootup is disabled.
Select the protocol that you want to use for the ISDN port.
Possible values:
• ) : The ISDN connection is not used.
• 51+  5)!
• 0 0
ISDN Configuration
Type
Only if Autoconfiguration on Bootup is disabled and for Port
Usage = 51+  5)! is set.
Select the ISDN connection type.
Possible values:
•   '1+ (default value): Point-to-multipoint
connection
•   : Point-to-point ISDN access.
The menu Advanced Settings consists of the following fields:
Fields in the Advanced Settings menu.
Field Description
X.31 (X.25 in D Chan-
nel)
Select whether you want to use X.31 (X.25 in the D channel)
e.g. for CAPI applications.
The function is enabled with "1.
The function is disabled by default.
X.31 TEI Value Only if X.31 (X.25 in D Channel) is enabled
With the ISDN autoconfiguration, the X.31-TEI is detected auto-
matically. If the autoconfiguration has not detected TEI, you can
manually enter the value assigned by the exchange.
Possible values are  to &.
8 Physical Interfaces bintec elmeg GmbH
144 bintec RS Series