BinTec RS120 - 11.5 Access Rules; 11.5.1 Access Filter

Caution
Make sure you don’t lock yourself out when configuring filters:
If possible, access your gateway for filter configuration over the serial console interface
or ISDN Login.
11.5.1 Access Filter
This menu is for configuration of access filter Each filter describes a certain part of the IP
traffic and defines, for example, the IP addresses, the protocol, the source port or the des-
tination port.
A list of all access filters is displayed in the Networking->Access Rules->Access Filter
menu.
Fig. 93: Networking->Access Rules->Access Filter
11.5.1.1 Edit or New
Choose the icon to edit existing entries. To configure access fitters, select the New but-
ton.
bintec elmeg GmbH
11 Networking
bintec RS Series 241