Field Description
The default value is (for automatic detection).
X.31 TEI Service Only for X.31 (X.25 in D Channel) = enabled
Select the service for which you want to use X.31 TEI.
Possible values:
• 63
• 63 5$1
• %: 7% (default value)
63 and 63 5$1 are only for the use of X.31 TEI for
CAPI applications. For 63, the TEI value set in the CAPI ap-
plication is used. For 63 5$1, the value of the CAPI ap-
plication is ignored and the default value set here is always
used.
%: 7% is set if you want to use X.31 TEI for the X.25
device.
8.2.2 MSN Configuration
In this menu, you can assign the available ISDN numbers to the required services (e.g.
PPP routing, ISDN login).
If you use the ISDN interface for outgoing and incoming dialup connections, your own num-
bers for this interface can be entered in this menu (these settings are not possible for
leased lines). Your device distributes the incoming calls to the internal services according
to the settings in this menu. Your own number is included as the calling party number for
outgoing calls.
The device supports the following services:
• PPP (Routing): The PPP (routing) service is your device's general routing service. This
enables ISDN remote terminals to establish data connections with your LAN, among oth-
er things. This enables partners outside your own local network to access hosts within
your LAN. It is also possible to establish outgoing data connections to ISDN remote ter-
minals.
• ISDN Login: The ISDN login service enables both incoming data connections with access
to the SNMP shell of your device, and outgoing data connections to other bintec elmeg
devices. As a result, your device can be remotely configured and administrated.
• IPSec: bintec elmeg devices support the DynDNS service to enable hosts without fixed
bintec elmeg GmbH
8 Physical Interfaces
bintec RS Series 145
To Next Page
Loading...
