Field Description
Displays the serial number of the list entry.
Interface Only for Mode = "1 $ +%$% $%
Displays the name of the interface.
Back Route Verify Only for Mode = "1 $ +%$% $%
Select whether ;%: A 9$( is to be activated for the
interface.
The function is enabled with "1.
By default, the function is deactivated for all interfaces.
11.2 NAT
Network Address Translation (NAT) is a function on your device for defined conversion of
source and destination addresses of IP packets. If NAT is activated, IP connections are still
only allowed by default in one direction, outgoing (forward) (= protective function). Excep-
tions to the rule can be configured (in NAT Configuration on page 211).
11.2.1 NAT Interfaces
A list of all NAT interfaces is displayed in the Networking->NAT->NAT Interfaces menu.
Fig. 85: Networking->NAT->NAT Interfaces
For every NAT interface, the )3* %, 0+"%: %, 1 5( and *
# can be selected.
In addition, $7# displays how many port forwarding rules were configured
11 Networking bintec elmeg GmbH
210 bintec RS Series
To Next Page
Loading...
