(3) Keep the Reset button on your device pressed down and switch the device back on.
(4) After the LED has flashed five times, release the Reset button.
Note
If you delete the boot configuration via the GUI (menu Maintenance->Software
&Configuration) all passwords are also reset and the current boot configuration is de-
leted. The next time, the device will boot with the standard ex works settings.
You can now configure your device again as described from Basic configuration on page 50
.
3.2 bintec RS120 and bintec RS120wu
3.2.1 Setting up and connecting
Note
All you need for this are the cables and antennas supplied with the equipment.
Caution
The use of the wrong mains equipment may damage your device. You should only use
the power supply unit provided! If you require foreign adapters/mains units, please
contact our bintec elmeg service.
Incorrect cabling of the ISDN and ETH interfaces may also damage your device. Con-
nect only the ETH interface of the device to the LAN interface of the computer/hub or a
WAN interface if available and the ISDN interface of the device only to the ISDN con-
nection.
bintec elmeg GmbH
3 Installation
bintec RS Series 15
To Next Page
Loading...