BinTec RS120 - Rtsp; RTSP Proxy

Field Description
You must configure a proxy for each destination port to which
VoIP clients from the LAN can connect.
The ports can be provider-specific.
The default value is .
Prioritize SIP Calls
Select whether you want to prioritise SIP Calls.
The function is enabled with "1.
The function is disabled by default.
17.2 RTSP
In this menu, you configure the use of the RealTime Streaming protocol (RTSP).
RTSP is a network protocol for controlling multimedia traffic flows in IP-based networks.
Payload data is not transferred using RTSP. Rather, it is used to control a multimedia ses-
sion between sender and recipient.
If you want to use RTSP, the firewall and NAT must be configured accordingly. In the VoIP-
>RTSP menu, you can activate the RTSP proxy to enable requested RTSP sessions over
the defined port if required.
17.2.1 RTSP Proxy
In the VoIP->RTSP->RTSP Proxy menu, you configure the use of the RealTime Streaming
protocol.
Fig. 147: VoIP->RTSP->RTSP Proxy
The VoIP->RTSP->RTSP Proxymenu consists of the following fields:
Fields in the Basic Parameters menu.
bintec elmeg GmbH
17 VoIP
bintec RS Series 391