BinTec RS120 - Reset

Property bintec RS353j , bintec RS353jw and bintec
RS353j-4G
CE symbol for all EU states
SAFERNET TM Security Technology Community passwords, PAP, CHAP, MS-CHAP, MS-
CHAP v.2, PPTP, PPPoE, PPPoA, Callback, Access Con-
trol Lists, CLID, NAT, SIF, MPPE Encryption, PPTP En-
cryption, VPN with PPTP or IPSec
Antenneas and sockets
Property bintec RS353j bintec RS353jw bintec RS353j-4G
WLAN interface
(antennas)
-
802.11a/b/g/h; 802.11n
2.4 GHz and 5 GHz;
2 TX, 2 RX (2x2)
Channel level (2.4 GHz /
5GHz) each 19 dB +/-1
dB
-
LTE - UMTS anten-
nas
- - SMA socket
GPS antennas - - SMA socket
Available sockets:
Ethernet interface RJ45 socket (yellow) RJ45 socket (yellow) RJ45 socket (yellow)
Ethernet interface RJ45 socket (white) RJ45 socket (white) RJ45 socket (white)
VDSL/ADSL RJ45 socket (gray) RJ45 socket (gray) RJ45 socket (gray)
ISDN BRI interface RJ45 socket (black) RJ45 socket (black) RJ45 socket (black)
USB USB-Anschluss type A USB-Anschluss type A USB-Anschluss type A
USB Console USB socket type B USB socket type B USB socket type B
WLAN - RSMA-Anschluss -
LTE - UMTS - - SMA socket
GPS - - SMA socket
3.1.6 Reset
If the configuration is incorrect or if your device cannot be accessed, you can reset the
device to the ex works standard settings using the Reset button on the back of the device.
All the existing data will be deleted if you do this.
Proceed as follows:
(1) Switch off your device.
(2) Press the Reset button on your device.
3 Installation bintec elmeg GmbH
14 bintec RS Series