BinTec RS120 - 3.3 bintec RS230 a, bintec RS230 aw and bintec RS230 au+; 3.3.1 Setting up and connecting

3.3 bintec RS230a, bintec RS230aw and bintec
RS230au+
3.3.1 Setting up and connecting
Note
All you need for this are the cables and antennas supplied with the equipment.
Caution
The use of the wrong mains equipment may damage your device. You should only use
the power supply unit provided! If you require foreign adapters/mains units, please
contact our bintec elmeg service.
Incorrect cabling of the ISDN and ETH interfaces may also damage your device. Con-
nect only the ETH interface of the device to the LAN interface of the computer/hub or a
WAN interface if available and the ISDN interface of the device only to the ISDN con-
nection.
3 Installation bintec elmeg GmbH
24 bintec RS Series