Property bintec RS120 bintec RS120wu
UMTS/WCDMS bands
900/1900/2100 MHz,
GSM/GPRS/EDGE bands
850/900/1800/1900 MHz,
Available sockets:
Serial interface V.24 5-pole mini USB socket 5-pole mini USB socket
Ethernet interface (yellow) RJ45 socket RJ45 socket
USB USB connection type A USB connection type A
Standards & Guidelines
R&TTE Directive 1999/5/EC
CE symbol for all EU states
R&TTE Directive 1999/5/EC
CE symbol for all EU states
SAFERNET TM Security
Technology
Community passwords, PAP,
CHAP, MS-CHAP, MS-CHAP v.2,
PPTP, PPPoE, PPPoA, Callback,
Access Control Lists, CLID, NAT,
SIF, MPPE Encryption, PPTP En-
cryption, VPN with PPTP or IPSec
Community passwords, PAP,
CHAP, MS-CHAP, MS-CHAP v.2,
PPTP, PPPoE, PPPoA, Callback,
Access Control Lists, CLID, NAT,
SIF, MPPE Encryption, PPTP En-
cryption, VPN with PPTP or IPSec
3.2.7 Reset
If the configuration is incorrect or if your device cannot be accessed, you can reset the
device to the ex works standard settings using the Reset button on the back of the device.
All the existing data will be deleted if you do this.
Proceed as follows:
(1) Switch off your device.
(2) Press the Reset button on your device.
(3) Keep the Reset button on your device pressed down and switch the device back on.
(4) After the LED has flashed five times, release the Reset button.
Note
If you delete the boot configuration via the GUI (menu Maintenance->Software
&Configuration) all passwords are also reset and the current boot configuration is de-
leted. The next time, the device will boot with the standard ex works settings.
You can now configure your device again as described from Basic configuration on page 50
.
bintec elmeg GmbH
3 Installation
bintec RS Series 23
To Next Page
Loading...
