BinTec RS120 - Page 36

Property bintec RS120 bintec RS120wu
Transport weight (incl. doc-
umentation, cables, pack-
aging)
approx. 1500 g approx. 1600 g
Memory
64 MB RAM,
16 MB flash ROM
64 MB RAM,
16 MB flash ROM
LEDs 14 (1x Power, 1x Status, 5x2 Eth-
ernet, 2x Function)
16 (1x Power, 1x Status, 5x2 Eth-
ernet, 4x Function)
Power consumption of the
device
4.7 Watt 4.7 Watt
Voltage supply 12 V DC 800 mA EU PSU 12 V DC 1,500 mA EU PSU
Environmental require-
ments:
Storage temperature -25 °C to +70 °C -25 °C to +70 °C
Operating temperature 0 °C to +40 °C 0 °C to +40 °C
Relative atmospheric hu-
midity
10 % to 95 % (non-condensing) 10 % to 95 % (non-condensing)
Room classification Only use in dry rooms. Only use in dry rooms.
Available interfaces:
Serial interface V.24 Permanently installed, supports
Baud rates: 1200 to 115200 Baud
Permanently installed, supports
Baud rates: 1200 to 115200 Baud
Ethernet IEEE 802.3 LAN
(4-port switch)
Permanently installed (twisted pair
only), 10/100/1000 mbps, auto-
sensing, MDIX
Permanently installed (twisted pair
only), 10/100/1000 mbps, auto-
sensing, MDIX
Ethernet Permanently installed (twisted pair
only), 10/100/1000 mbps, auto-
sensing, MDIX
Permanently installed (twisted pair
only), 10/100/1000 mbps, auto-
sensing, MDIX
SFP LAN Port SFP Slot for common optical
10/100/1000 mbps Ethernet SFP
modules, not hotswap-capable
SFP Slot for common optical
10/100/1000 mbps Ethernet SFP
modules, not hotswap-capable
WLAN interface (antennas) -
802.11a/b/g/h with antenna di-
versity; data rates of 1-, 2-, 5.5-, 6-,
9-, 11-, 12-, 18-, 24-, 36-, 48-, 54
mbps
802.11n; data rates up to 300
mbps
UMTS/GPRS -
Support for UMTS, HSxPA
(HSDPA with up to 7.2 mbps,
HSUPA with up to 2.0 mbps),
GPRS, Edge and GSM, LTE;
3 Installation bintec elmeg GmbH
22 bintec RS Series