11.1.3 Options
Back Route Verify
The term Back Route Verify describes a very simple but powerful function. If a check is ac-
tivated for an interface, incoming data packets are only accepted over this interface if out-
going response packets are routed over the same interface. You can therefore prevent the
acceptance of packets with false IP addresses - even without using filters.
Fig. 84: Networking->Routes->Options
The Networking->Routes->Optionsmenu consists of the following fields:
Fields in the Back Route Verify menu.
Field Description
Mode Select how the interfaces to be activated for Back Route Verify
are to be specified.
Possible values:
• "1 $ 11 $%: Back Route Verify is activ-
ated for all interfaces.
• "1 $ +%$% $% (default value): A list
of all interfaces is displayed in which Back Route Verify is only
enabled for specific interfaces.
• 5"1 $ 11 $%: Back route verify is dis-
abled for all interfaces.
No. Only for Mode = "1 $ +%$% $%
bintec elmeg GmbH
11 Networking
bintec RS Series 209
To Next Page
Loading...
