Field Description
• AD (default value): Incoming data traffic is monitored.
• *D: Outgoing data traffic is monitored.
Interface Traffic Condi-
tion
Only for Event Type $% *$$%
Select whether the value for data traffic must be
(default value) or 0 the value specified in *$
*$$% in order to initiate the operation.
Transferred Traffic
Only for Event Type $% *$$%
Enter the desired value in kBytes for the data traffic to serve as
comparison.
The default value is .
Destination IP Address
Only for Event Type # *
Enter the IP address whose accessibility is to be checked.
Source IP Address
Only for Event Type # *
Enter an IP address to be used as sender address for the ping
test.
Possible values:
• 3% (default value): The IP address of the interface
over which the ping is sent is automatically entered as sender
address.
• +%$%: Enter the desired IP address in the input field.
Status
Only for Event Type # *
Select whether Destination IP Address A%"1 must be
(default value) or .%"1 in order to initiate the opera-
tion.
Interval
Only for Event Type # *
Enter the time in Seconds after which a ping must be resent.
The default value is seconds.
Trials
Only for Event Type # *
bintec elmeg GmbH
18 Local Services
bintec RS Series 429
To Next Page
Loading...
