BinTec RS120 - Page 55

Property bintec RS232j bintec RS232jw bintec RS232j-4G
Power consumption
of the device
4.7 Watt 4.7 Watt 4.7 Watt
Voltage supply 12 V DC 800 mA EU
PSU
12 V DC 800 mA EU PSU 12 V DC 800 mA EU
PSU
Environmental re-
quirements:
Storage temperat-
ure
-25 °C to +70 °C -25 °C to +70 °C -25 °C to +70 °C
Operating temper-
ature
0 °C to +40 °C 0 °C to +40 °C 0 °C to +40 °C
Relative atmo-
spheric humidity
10 % to 90 % non-
condensing in operation,
5 % to 95 % non-
condensing when stored
10 % to 90 % non-
condensing in operation,
5 % to 95 % non-
condensing when stored
10 % to 90 % non-
condensing in operation,
5 % to 95 % non-
condensing when stored
Room classification Only use in dry rooms. Only use in dry rooms. Only use in dry rooms.
Available inter-
faces:
ADSL interface Internal ADSL2+ modem
for Annex B / J
Internal ADSL2+ modem
for Annex B / J
Internal ADSL2+ modem
for Annex B / J
Serial interface
V.24
Permanently installed,
supports Baud rates:
1200 to 115200 Baud
Permanently installed,
supports Baud rates: 1200
to 115200 Baud
Permanently installed,
supports Baud rates:
1200 to 115200 Baud
Ethernet IEEE
802.3 LAN (4-port
switch)
Permanently installed
(twisted pair only),
10/100/1000 mbps, auto-
sensing, MDIX
Permanently installed
(twisted pair only),
10/100/1000 mbps, auto-
sensing, MDIX
Permanently installed
(twisted pair only),
10/100/1000 mbps, auto-
sensing, MDIX
Ethernet Permanently installed
(twisted pair only),
10/100/1000 mbps, auto-
sensing, MDIX
Permanently installed
(twisted pair only),
10/100/1000 mbps, auto-
sensing, MDIX
Permanently installed
(twisted pair only),
10/100/1000 mbps, auto-
sensing, MDIX
ISDN BRI (S0) Built-in, only TE mode Built-in, only TE mode Built-in, only TE mode
WLAN interface
(antennas)
-
802.11a/b/g/h with an-
tenna diversity; data rates
of 1-, 2-, 5.5-, 6-, 9-, 11-,
12-, 18-, 24-, 36-, 48-, 54
mbps
802.11n; data rates up to
300 mbps
-
UMTS/GPRS/LTE
Support for UMTS,
HSxPA (HSDPA with up
bintec elmeg GmbH
3 Installation
bintec RS Series 41