connect to the device via SSH:
*&+,+ ) &
*& -& .+ / 0!
-12(3 4 4 55 66 217&(
-8 9 554 66 &&+%7+&7&7:2
-8 554 66 &&+%7+&7&7:
-8 49 554 664 &&+%7+&7%&7:2
-8 4 554 66 &&+%7+&7%&7:
*&+,+ )
Note
The device generates a key pair for each of the algorithms (RSA and DSA), i.e. two
files must be stored in the flash for each algorithm (see example at above).
If no keys are available, you have to generate these first. Proceed as follows:
(1) Leave the Flash Management shell with 1.
(2) Launch the GUI and log on to your device (see Calling up GUI on page 69).
(3) Make sure that 5% is selected as the language.
(4) Check the key status in the System Management->Administrative Access->SSH
menu. If both keys are available, you'll see in both fields RSA Key Status and DSA
Key Status the value
(5) If one or both of these fields contains the value ) #, you must generate
the relevant key. To have the device generate the key, click Generate.
The device generates the corresponding key and stores it in the FlashROM.
indicates successful generation.
(6) Make sure that both keys have been successfully generated. If necessary, repeat the
procedure described above.
Login via SSH
Proceed as follows to log in on your device via SSH:
If you have made sure that all the keys needed are available on the device, you have to
check whether an SSH client is installed on your PC. Most UNIX and Linux distributions in-
stall a SSH client by default. Additional software, e.g. PuTTY, usually has to be installed on
5 Access and configuration bintec elmeg GmbH
62 bintec RS Series
To Next Page
Loading...
