reaches the BOOTmonitor mode. The BOOTmonitor prompt is displayed if you are serially
connected to your device.
After display of the BOOTmonitor prompt, press the space bar within four seconds to use
the functions of the BOOTmonitor. If you do not make an entry within four seconds, the
device changes back to normal operating mode.
Note
If you change the baudrate (the preset value is 9600 baud), make sure the terminal
program used also uses this baudrate. If this is not the case, you will not be able to es-
tablish a serial connection to the device.
bintec elmeg GmbH
5 Access and configuration
bintec RS Series 79
To Next Page
Loading...
