S10/S12/S10A/S12A Patient Monitor User’s Manual
15-15
Do not apply excessive tension to the CO2 sensor cable.
When aerosol drugs are present, please keep the airway adapter away from the
breathing circuit. The viscous substance of the aerosol drug can pollute the
window of the airway adapter, and the airway adapter needs to be cleaned or
replaced in advance.
For further information on the use of Masimo IRMA CO2 mainstream module
and Nomoline ISA CO2 module, please refer to the user’s manual included with
the module.
NOTE:
This product and its accessories are latex free.
After the life cycles of the CO
2
module and its accessories have been met,
disposal should be accomplished following national and local requirements.
Nitrous oxide, elevated levels of oxygen and helium can influence the CO2
measurement. Please setup gas compensation according to actual state.
Barometric pressure compensation is required to meet the stated accuracy of the
CO2 module.
Do not place the airway adapter between the ET tube and the elbow, as this may
allow patient secretions to block the adapter windows.
Position the airway adapter with its windows in a vertical and not a horizontal
position, this helps keep patient secretions from pooling on the windows.
15.12. CO
2
Troubleshooting
This chapter describes the problems that may be encountered during the use of the
monitor. You can first refer to the following table to eliminate them. If the problem
persists, please contact the maintenance personnel.
CAUTION:
For the physiological and technical alarm messages, see D Alarm Message.
To Next Page
Loading...