S10/S12/S10A/S12A Patient Monitor User’s Manual
7-4
7.3.4. Alarm Status Symbols
In addition to the alarm methods described in section Alarm Indicators, the
following alarm icons will appear on the screen to indicate different alarm states:
Indicates an alarm for a parameter is off or the alarm system is off.
Indicates all the alarms are paused.
Indicates the alarm sound is off.
Indicates
alarms are reset.
7.4. Viewing physiological alarms list
The steps of viewing physiological alarms are as follows:
1. Selectphysiological alarms area to enter【Alarm Informations】window.
2. Select【Phy. Alarm】submenu.
7.5. Viewing technical alarms list
The steps ofviewing technical alarms list are as follows:
1. Selecttechnical alarms area to enter
【
Alarm Informations
】
window.
2. Select【Tec. Alarm】submenu.
7.6. Setting Alarm
You can set the alarm properties centrally. Select【Alarm Setup】quick keyor select
the corresponding button from the【Alarm】column,
in the main menu to set alarm.
7.6.1. Setting Parameter Alarm
The steps to centrally set the properties of the parameter alarm are as follows:
1. Enter【Limit】interface in any of the following ways:
Select 【Alarm Setup】 quick key.
Select 【Main Menu】 quick keyfrom【Alarm】column to select【Limit】.
2. Select parameter submenu to set the alarm according to the required. You can
also set the alarm for individual parameters from the parameters menu.
To Next Page
Loading...