S10/S12/S10A/S12A Patient Monitor User’s Manual
5-1
Chapter 5 Managing Configurations
5.1. Introduction
When performing continuous monitoring on a patient, the clinical professional often
needs to adjust the monitor’s settings according to the patient’s condition. The collection
of all these settings is called a configuration. The configuration of the monitor includes:
parameter configuration, alarm configuration and monitor configuration. You can change
some settings from a certain set of configuration and then save the changed configuration
as a user configuration.
WARNING：
The configuration management function is password protected. The
configuration management tasks must be performed by clinical professionals.
5.2. Selecting default configuration
The monitor will load the pre-set default configuration in the following cases.
The patient monitor restarts after a normal shutdown.
Admit new patients.
The default configuration can be the factory default configuration or a user
configuration that has been stored.
You can use the following steps to select the default configuration:
1. Select【Main Menu】quick keyfrom【Configuration】column to select
【Set Default Config】input maintenance passwordEnter.
2. Select【Factory Default】or User-defined configuration.
When selecting user-defined configuration, only one user configuration that has been
stored under the current patient type can be selected.
5.3. Saving current settings
Current settings can be saved as user configuration. Up to 10 user configurations can
be saved. The steps to protect the current settings are as follows:
1. Select【Main Menu】quick keyfrom【Configuration】column to select
To Next Page
Loading...