Biolight Meditech S10 - Monitor Boot Usage Configuration; Setting Password Valid Time

S10/S12/S10A/S12A Patient Monitor User’s Manual
5-4

 【Current】: The monitor loads the nearest configuration when it
receives the patient.
5.8. Monitor Boot Usage Configuration
When the monitor starts, you can select whether the monitor loads the nearest
configuration or the specified configuration. You can set the default configuration by
following these steps:
1. Select【Main Menu】quick keyfrom【Configuration】column to select
【Boot Config】input maintenance passwordEnter.
2. Select【Default】or【Current】.
 【Default】: The monitor loads the default configuration specified by
the user
 the user when it starts. Please refer to 5.2 Selecting Default
Configuration.
 【Current】: The monitor loads the nearest configuration when it starts.
5.9. Setting password valid time
If you access the configuration management menu and use the password to access
alarm-related settings, you can set a valid time for the password, beyond which you will
need to re-enter the password.
Please follow the steps below:
1. Select 【 Main Menu 】 quick keyfrom 【 System 】 column to select
【Maintenance】input maintenance passwordEnter.
2. Select【Authorization】submenu.
3. Set【Retention Time】.