Biolight Meditech S10 - Maintenance Item

S10/S12/S10A/S12A Patient Monitor User’s Manual
50
Item Default Setting
Touch Tone OFF
NIBP End
Tone
OFF
C.15 Maintenance Item
Item Default Setting
Network Type LAN
LAN IP Use the following IP address
Frequency 2.4G
Device No. 8
Alarm Pause Time 2min
Minimum alarm volume 2
Alarm sound ISO
High priority alarm tone interval (s) 10
Med priority alarm tone interval (s) 20
Low priority alarm tone interval (s) 20
Other bed alarm reset OFF
Reset by alarm of other bed OFF
Alarm close prompt ON
Prompt tone interval 5min
ECG lead-off level MED
Alarm delay OFF
Notch filter 50 Hz
Nurse
call
Signal type Pulse
Trigger method N.O.
Alarm level All
Alarm type Technical Alarm & Physiological Alarm