S10/S12/S10A/S12A Patient Monitor User’s Manual
19-2
Select【Main Menu】quick keyfrom【Calculations】column to select
【Drug】.
2. Set 【Drug Name】 and 【Patient Type】. If the selected drug is affected
by weight, switch on 【Weight Participation】 and enter the patient’s
weight.
3. Enter the drug-related information such as total amount, volume and dose of
drugs.
4. Select 【Calculate】 button to calculate. Red arrow marks are displayed
before the calculation results.
CAUTION:
If available, the patient category and weight from the patient demographics
menu are automatically entered when you first access drug calculation. You can
change the patient category and weight. This will not change the patient category
and weight stored in the patient demographic information.
19.3.2. Checking the Titration Table
The Titration Table shows informations on the currently used drugs. You can
check the dose received by the patient at different infusion rate through the Titration
Table. The procedure for viewing the titration table is as follows:
1. Access drug calculation page by either of the following ways:
Select【Calculations】quick key.
Select【Main Menu】quick keyfrom 【Calculations】 column to
select 【Drug】.
2. Select 【Titration】 sub menu.
3. Select 【Dose Type】 at the bottom of the interface to set the unit type of drug
dose in the titration table.
4. Select 【Step】 to set the interval between two adjacent titration table item.
You can choose the sorting method of titration table:
【Dose】: The titration table is listed in the sequence of increased drug
To Next Page
Loading...