S10/S12/S10A/S12A Patient Monitor User’s Manual
19-10
select 【Ventilation】.
2. Enter the correct value for each parameter. For a patient who is being
monitored, the currently measured values are automatically taken. If the
anesthesia machine or ventilator is connected, measured values for ventilation
calculation are also automatically taken.
3. Select 【Calculate】 to calculate the value of each output parameter. The
calculated value is greater than the normal upper limit is indicated by an up
arrow “”; the calculated value is lower than the normal lower limit is
indicated by a down arrow “”.
On the ventilation page, you can also perform the following operations:
Select 【Pressure Unit】, then corresponding parameter values will be
automatically converted and updated accordingly.
Select 【Range】 to show the normal range of each parameter.
Select 【Unit】 to show the unit of each parameter.
19.6.2. Input Parameter
Input Parameter Unit Full Name
FiO2 % percentage fraction of inspired oxygen
RR rpm respiration rate
PeCO2 mmHg, kPa partial pressure of mixed expiratory CO2
PaCO2 mmHg, kPa partial pressure of carbon dioxide inthearteries
PaO2 mmHg, kPa partial pressure of oxygen in the arteries
TV mL tidal volume
RQ respiratory quotient
ATMP mmHg, kPa atmospheric pressure
To Next Page
Loading...