S10/S12/S10A/S12A Patient Monitor User’s Manual
3-7
enter the maintenance password.
2.
Select
【
Other
】
submenu.
3. Select【Language】and then select the desired language.
4. Restart the patient monitor.
3.5.2. Adjusting the Screen Brightness
The steps to set the screen brightness are as follows:
1. Set the brightness in one of the following ways:
Select
【
Brightness
】
quick key.
Select
【
Screen Setup
】
quick keyselect
【
Other
】
submenu.
2. If the monitor operates on AC power，please set 【Brightness】；If the patient
monitor operates on battery power，please set【Brightness On Battery】.
3.
When the
【
Brightness
】
set as
【
Auto
】
,the screen will change to the
brightness automatically according to the environment light intensity.
NOTE
：
When the patient monitor enters standby mode, the screen brightness will be
automatically adjusted to the lowest.
When the AC power is interrupted and the battery is powered, the screen
brightness is automatically set to the corresponding brightness when the
battery is powered. You can still manually adjust the brightness as needed.
3.5.3. Setting the Date and Time
1. Select【Main Menu】from【System】column to select【Time】, enter the
【System Time】.
2. Select【Date】and【Time】to
set the current date and time.
3. Select【Date Format】.
4. If you need to use 12 hours format, turn off 【24-Hour】.
To Next Page
Loading...