Biolight Meditech S10 - Page 46

S10/S12/S10A/S12A Patient Monitor User’s Manual
4-3

4.3.2. Editing Patient Information
Edit patient information after a patient has been admitted, or when patient
information is incomplete, or when you want to change patient information.
To edit patient information, follow this procedure:
1. Enter the 【Patient Management】 menu. For more information,
please refer
to 4.3.1 Patient Management menu.
2. Select patient type according to the actual situation: 【Adult】, 【Pediatric】,
【Neonate】.
3. Edit patient information as required.
If your monitor is connected with the barcode scanner, you can enter the medical
record number by scanning the barcode.
NOTE
：
 The setting of patient type determines the algorithm used by the monitor to
process and calculate certain measurements, as well as the safety limit and
alarm limit range applicable to certain measurements.
 The monitor reloads the configuration when the patient type is changed.
4.3.3. Setting the Display Item
You can set whether to display and edit patient room number, middle name, race, age,
and so on in the 【Patient Management】 menu by following these steps:
1. Select 【 Main Menu 】 quick keyfrom 【 System 】 column to select
【Maintenance】input passwordEnter.
2. Select【Patient Management】submenu【Field】submenu.
3. Select which the patient information needs to be displayed and edited in the
【Patient Management】 menu.
4. Select customizes the patient information section, if necessary, and enters the
name of the section.