S10/S12/S10A/S12A Patient Monitor User’s Manual
6-6
6.4.1.3. Adding Other Bed
Only add other bed monitor, the device can monitor alarm of other bed. If you have
added other bed monitor, you can up to a choice of 16 beds. Add other bed as follows:
1. Select other bed observation interface area, in the pop-up window 【Bed
View Settings (Bed number)】to select 【Bed】submenu.
2. Select the device number of the monitor to be observed in the list.
The setup interface mainly displays the device number, IP, and patient
information of the networked monitor.
Select【Show Offline Bed】to display the device numbers of all monitors.
6.4.1.4. Delete Bed
If you no longer need to monitor the remote monitor, you can remove it as follows:
1. Select other bed observation interface area, in the pop-up window【Bed View
Settings (Bed number)】 to select【Bed】submenu.
2. Cancel the device number of the monitor
in the list. If you want to delete all
beds, you canselect【Delete All】.
6.4.1.5. Display Main Bed
In the other bed monitoring area of its bed observation window, select a bed and
then other bed observation window will display the real-time monitoring interface of the
monitor. This selected bed is called the main bed.
6.4.1.6. Alarm information Display
You can follow these steps to view the current real-time alarm information of the
main bed:
1. Enter【Alarm】interface
by one of the following methods:
Click on the alarm information display area of the bed observation area, and
the alarm interface will pop up.
Select other bed observation interface area, in the pop-up window【Bed
View Settings (Bed number)】 to select【Alarm】submenu.
To Next Page
Loading...