Biotage Isolera Four - Page 11

411829-L, Description and Specifications April 2012 Page 1-5
1
Sample Loading Methods for Biotage ZIP Cartridges
Liquid samples can be injected into the Biotage ZIP cartridge inlet Luer fitting using a syringe or,
when using an Isolera LS system, the sample loading pump.
Dried, preadsorbed sample on media can be loaded externally using a dry load vessel (DLV-030 or
DLV-070).
Collection Racks and Vessels
The Isolera software comes with a preconfigured list of Biotage collection racks. The vessel size
range is from 9 ml test tubes to 480 ml bottles. You may add other racks to this list (see “Add a
Rack Type” on page 2-5).
* Only included in the preconfigured list for Isolera Prime, Isolera One, and Isolera Four. Not
recommended on Isolera LS.
†
Only included in the preconfigured list for Isolera LS.
Figure 1-3. Typical Racks Used with Isolera
Rack Type
Vessel Diameter x
Length
Vessel
Volume
No of
Vessels
No of Racks
per Tray
13 x 100 mm* 13 mm x 100 mm 9 ml 48 4
16 x 100 mm* 16 mm x 100 mm 14 ml 35 4
18 x 130 mm 17.5 mm x 130 mm 18 ml 28 4
16 x 150 mm* 16 mm x 150 mm 22 ml 35 4
18 x 150 mm 18 mm x 150 mm 27 ml 28 4
25 x 150 mm 25 mm x 150 mm 45 or 53 ml 15 4
120 ml 120 ml bottles 120 ml 6 4
240 ml 240 ml bottles 240 ml 18 1
480 ml 480 ml bottles 480 ml 10 1
Funnel rack
†
Any vessel up to 10 l Up to 10 l 32 1