Operation Instruction manual GSP
44 / 92 38107010002 en-US
6.2.1 Slicing long product
Move carriage towards operator.
Using handle, pull product holder out-
wards, swivel it upwards and lock it in
end position.
Fig.44: Preparation of machine
Place product on carriage rear wall and
move to gauge plate.
Position the product fixation device or
product guide against the product.
Turn in product holder and position on
the product.
Switch on machine.
Set slice thickness at knob.
Set stroke width and number of carriage
strokes or change after start.
Fig.45: Load the product
To Next Page
Loading...
