Bizerba GSP H - Switching the Slicer On and Off

Installation Instruction manual GSP
28 / 92 38107010002 en-US
Use of lubricants in the production process.
Substances not intended to get in contact with food could be present on
the surfaces of the machine.
– Clean thoroughly before start-up. [}56]
4.3.1 Switching the slicer on
- Requirement for some options [}34]:
- The slice thickness at the rotary knob must be smaller/ equal "0".
<I> (green) Used to switch on blade motor
<O> (red) Blade motor is switched off (reduced operating force)
GSPH, GSP H Flex:
Press <I> (green).
Signal lamp (white) lights up.
The blade motor rotates.
GSPHD:
Press <I> (green).
Signal lamp (white) lights up as soon as
mains voltage is applied.
Blade starts running automatically, if op-
tion blade start [}34] is activated.
Fig.13: ON / OFF button
GSP H W, GSP HD W:
Press <I> (green).
Blade starts running automatically, if op-
tion blade start [}34] is activated.
Fig.14: ON / OFF button
4.3.2 Switching the machine off
Press <O> (red). (reduced operating force)
or
Option switch-off zero [}34]: set the slice thickness at the rotary knob smaller/equal "0"
while the blade motor runs.
Remove the AC power plug.
Machine is switched off.