Maintenance Instruction manual GSP
70 / 92 38107010002 en-US
The time intervals are dependent on the wear and tear of the blade and/or its operating us-
age as also the properties and conditions of the product.
NOTICE! For safety reasons, the blade may
only be ground to an annular gap of max.
6mm between blade and guard ring.
Fig.101: Annular gap
8.6.1 Sharpening device
The sharpener identified by the machine number has been adjusted for this machine.
The device is fitted with a coarse sharpening stone and a finely grained honing stone. Dirty or
greasy sharpening stones do not sharpen well.
Before sharpening, clean with brush and solving detergent.
If sharpening stones are worn, replace stones.
Replacement parts are supplied by Bizerba customer services.
When replacing, do not confuse sharpening and honing stones.
8.6.2 Preparation for sharpening
Remove parts and clean machine. [}56] [}64]
Tilt the carriage back in and screw into place.
Place paper felt or thin cardboard on carriage and cut off a few strips in order to entirely
remove grease from blade.
Switch off machine.
Remove the paper felt.
Tilt deflector away from blade.
To Next Page
Loading...
Need help?
General
