Bizerba GSP H - Honing and Sharpener Removal

Maintenance Instruction manual GSP
72 / 92 38107010002 en-US
Switch on machine.
Set marking to "1".
The sharpening stone is engaged.
Sharpen until right blade edge shows a
burr.
Set marking to "0".
Switch machine off, wait until blade
stops rotating.
Fig.104: Marking
Checking burr:
Using a pen or pencil, touch the right edge of the blade while moving the pen from inside
to outside.
Burr must be noticeable, otherwise the sharpening procedure must be re-
peated.
8.6.5 Honing
Start blade motor.
Set marking to "2".
The honing stone is engaged.
Hone until a honing bevel of about 0.5 -
1mm can be seen on the right blade
edge (after about 3-4seconds)
Set marking to "0".
Switch machine off, wait until blade
stops rotating.
Fig.105: Marking