Instruction manual GSP Troubleshooting
38107010002 en-US 55 / 92
7 Troubleshooting
7.1 Procedure
Should there be a stoppage and the problem cannot be corrected right
away, food products have to be removed for protection in compliance with
the maximum limit of 30 minutes for products to remain on the machine.
Switch off machine immediately if untypical noises are heard or if there is a suspected
risk of injury.
Inform your respective Customer Services if you cannot remove the fault yourself.
Please provide the Bizerba customer service with the following information:
– Machine type (see identification plate),
– Machine number (see identification plate),
– Error description.
This will make preparation of the customer service assignment much easier.
7.2 Fault description
The described malfunction can be remedied by the user himself.
Interference Possible cause Solution
Machine does not react to
touch of the touchscreen
Cleaning agents residues Clean operating panel with keypad
and touchscreen using a damp
cloth
Clean your hands
Carriage can not be tilted
outwards
The tilt lock has not been
released
Set cutting thickness with turning
knob to below "0"
Dissatisfactory slicing re-
sult
Blunt blade
Resharpen blade [}69]
Poor sharpening result Grinding disks are dirty or
greasy
Clean the sharpening stone [}70]
It is not possible to
sharpen the blade
The blade has been
sharpened past the per-
mitted 6 mm
Replacing blade
To Next Page
Loading...
Need help?
General
