Maintenance Instruction manual GSP
64 / 92 38107010002 en-US
8.4 Cleaning plan for slicers
Work steps Recom-
mended clean-
ing agents
Procedure Cleaning devices Notes
Preparatory
measures
Close slice thick-
ness, switch off
machine, pull out
power plug
Disassemble
all removable
parts
according to in-
struction manual
Rough clean-
ing
(not neces-
sary for ma-
chines with
Ceraclean)
Remove any
product rem-
nants manually
Plastic deflector,
plastic spatula,
brush
Start immediately
after production has
finished, if neces-
sary, begin with the
removed parts
Cleaning 1% P3-steril After thorough
pre-rinsing with
water
manually, brush
(not for slicers
with Ceraclean),
tub, disposable
cloth
all disassembled
and permanent
parts of machine
Water pressure < 6
bar
Manual sprayer * see comment
Dishwasher Removed parts ex-
cept blade cover
Acid cleaning
Additional
measure
(not neces-
sary for ma-
chines with
Ceraclean)
squirt some
Renolit Surf in
the pail
application
time is max.
15 min.
Manually, me-
chanically
Brush for remov-
ing lime residue
only if required for
lime residue
rinse immediately
after cleaning
Foam without
pressure
Manual sprayer * see comment
Rinse Rinse with drink-
ing water
Water hose
Manual sprayer
removed parts
Water pressure < 6
bar
Checking visually on opti-
cal cleanliness
Drying rub dry or leave
to dry
Disposable cloth Leave dismantled
parts apart from one
another to dry
To Next Page
Loading...
Need help?
General
