Instruction manual GSP Attachment
38107010002 en-US 91 / 92
10.3 Checklist installation and start-up
Installation requirements to be met by customer
Done
The machine and components to be installed are located at the place of installa-
tion.
Machines for which the power is supplied via power plug (Schuko, CEKON, Per-
ilex, ...) must be fitted with a suitable power socket within the connection range
(max. distance of 1 m) of the machine allowing the machine to be connected with
the provided power cable.
For machines which are provided with a permanently connected power supply by
the factory a suitable supply circuit disconnect is provided for each machine.
The supply circuit disconnect is accessible to the Bizerba service technician at
any time and w/o tools (ladder etc.).
Scope of performance regarding installation
Done
Installation between Bizerba and end customer coordinated.
Machines and components were unpacked and packaging returned.
Machine has been correctly installed and aligned.
(Machine is secured accordingly: if table mounted, holes for fixing pins are drilled
or if bench mounted, machine is fastened with fixing pins.)
Machine is connected to customer provided socket.
Functionality of machine and provided components tested, trial run and optimiza-
tions carried out.
Electrical safety meets relevant country-specific regulations. (In Germany DIN-
VDE 0701)
Staff was instructed.
– Operation of the machine
– Maintenance, care, cleaning as described in instruction manual
– Disassembly of the parts that require cleaning and cleaning of the machine
– Information on blade sharpening by using sharpening service, disassembly of
blade
Installation and training approved and signed on service report.
Date:
To Next Page
Loading...
Need help?
General
