Instruction manual GSP Operation
38107010002 en-US 45 / 92
Start carriage motor.
Slices drop on depositing area.
Stop carriage motor.
The carriage runs towards the operator,
the blade is on hold.
Once the slicing process is completed
set slice thickness to "0".
Switch off machine.
Fig.46: Slice product
Extra care must be taken due to additional risk of injury if product holder is
not used and positioned underneath the carriage.
6.2.2 Slicing product ends
The product holder is force-guided in an area of < 60mm to the blade and
cannot be swiveled up.
Move carriage towards operator.
Using handle, pull product holder out-
wards, swivel it upwards and lock it in
end position.
Fig.47: Preparation of machine
To Next Page
Loading...
