98
GPIB (895 Only)
The GPIB address of the LCR meter can be configured from 1-31. To communicate via GPIB,
connect a GPIB cable to the GPIB port at the back of the LCR meter. Refer 8.1, GPIB ADDR (895
only), for more information.
Remote Commands
The instrument supports some SCPI commands and some instrument specific commands. These
commands enable a computer to remotely communicate and control the instrument over any of
the supported remote interfaces: USBTMC, RS-232, LAN, and GPIB (895 only).
Refer to the programming manual for details, which can be downloaded from
www.bkprecision.com
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
