When entering 'scene' metadata, your URSA Mini will prompt you with increment
suggestions to the left of the touch keyboard, and shot types to the right
Take
The ‘take’ indicator shows the take number for the current shot. You can increment this up or
down by tapping the left or right arrows on either side of the take number, or tapping the
indicator to enter the take number editor.
You can add take descriptions in the take number editor. These are offered to the right of the
take number keyboard, and correspond to the following scenarios:
PU
‘Pick up.’ This refers to a reshoot of a previous take to add
additional material after principal photography has wrapped.
VFX
‘Visual effects.’ This refers to a take or shot for visual effect use.
SER
'Series.' This refers to a situation in which multiple takes are shot
while the camera is kept running.
When entering 'take' metadata, your URSA Mini will offer prompts for additional
shot types to the right of the touch keyboard
TIP When the shot number or scene letter are advanced, the take number will
revert to ‘1.’
Tap 'A' to enable 'auto take
increment' whilst in 'standby'
mode. This will automatically
advance the take number
for each clip recorded. A
small 'A' will appear next to
the take number on the slate
when enabled.
130Entering Metadata
To Next Page
Loading...
