Blackmagicdesign URSA Mini - Blackmagic URSA Mini Pro PL Mount

Keep reading this section for details about the PL, B4, F and EF lens mount kits and how to
install each mount to your URSA Mini Pro 4.6K.
Blackmagic URSA Mini Pro PL Mount
Attaching the PL mount to your URSA Mini Pro 4.6K lets you use high end precision
cinemalenses for feature film and television production.
The PL mount kit includes:
1 x PL mount
The PL mount is shipped with a protective
dust cap.
1 x Shim set
The shim set includes the following thicknesses:
0.50mm
0.30mm
0.20mm
0.18mm
0.15mm
0.12mm
0.10mm
0.05mm
0.025mm
1 x PL baffle
The PL mount baffle helps to control and direct the
light entering the sensor.
1 x Baffle tool
Use the PL baffle tool to tighten the baffle in
your camera.
5 x 2mm Hex M2.5 x 22mm mount screws
The five M2.5 x 22mm Hexscrews are exclusive to
the PLmount so you can keep the screws together
with the respective mount.
The PL mount kit also comes with a full spare sets
of screws in case the originals are misplaced.
NOTE When removing the original EF mount, make sure the 0.10mm and 0.50mm
shims underneath the mount always stay attached to your camera.
195Interchangeable Lens Mount