Blackmagicdesign URSA Mini - Blackmagic URSA Mini Pro EF Mount

Blackmagic URSA Mini Pro EF Mount
The EF mount can be purchased if you ever need to replace the original EF mount that is
shipped with your camera.
The EF mount kit includes:
1 x EF mount
The EF mount lets you attach common
EFstills lenses.
1 x Shim set
The shim set includes the following thicknesses:
0.50mm
0.30mm
0.20mm
0.18mm
0.15mm
0.12mm
0.10mm
0.05mm
0.025mm
1 x Baffle tool
The baffle in the EF mount is not removable,
however we have included a baffle tool in the
EFkit as a spare item you can use if you also have
the PL mount.
4 x 2mm Hex M3 x 18mm mount screws
The four M3 x 18mm Hex screws are used in the EF
and F mount so it is best to keep the screws
together with the respective mount.
The EF mount kit also comes with a full spare sets
of screws in case the originals are misplaced.
Tools Required
When attaching the EF mount, you will need a 2mm Hex driver. While it’s not absolutely
required, we recommend using a torque wrench able to accurately set a maximum torque
of0.45Nm to reduce the potential of over tightening the screws.
2mm Hex driver
202Interchangeable Lens Mount