Bosch DS7200V2-EXP - Figure 40: DX3010 to Control Panel Wiring; Figure 41: DX3010 Output States; Figure 42: DX3010 to Control Panel Wiring (External Power Supply); Table 11: DX3010 Wire Lengths

DS7200V2-EXP | Installation Guide | 2. System Installation
and Setup
EN | 30
Bosch Security Systems, Inc. | 04/12 | F01U253045-02
Distance from the control panel is determined by
the total combined wire length of all devices
(including keypads) connected to the control
panel’s Data Bus terminals. The combined wire
length must not exceed 305 m (1007.7 ft) using
0.8 mm (#22 AWG) wire.
2.7.4 DX3010 Wiring
See Table 11 for Data Bus wire length
requirements.
Table 11: DX3010 Wire Lengths
Power
Source
0.8 mm
(#22
AWG)
1.2 mm
(#18 AWG)
Control Panel
to DX3010
Control
Panel
12.2 m
(40 ft)
24.4 m
(80 ft)
Control Panel
to DX3010
Externa
l Power
Supply
305 m
(1007.7
ft)
610 m
(2001 ft)
External Power
Supply to
DX3010
12.2 m
(40 ft)
24.4 m
(80 ft)
Figure 40: DX3010 to Control Panel
Wiring
1- DX3010 Module
2- Control panel board
3- Yellow (Y) data wire
4- Green (G) data wire
5- Black (-) wire
6- Red (+) wire
You can use either one of the Aux Power (-)
terminals and either one of the 12 VDC (+)
terminals when connecting devices to the control
panel.
Figure 41: DX3010 Output States
1- Output activated state
2- Output deactivated state
If you need to power the DX3010 from an
external power supply, connect it to the power
supply and the control panel.
Figure 42: DX3010 to Control Panel
Wiring (External Power Supply)
1- DX3010 Module
2- Control panel board
3- Yellow (Y) data wire
4- Green (G) data wire
5- Black (-) wire
6- Red (+) wire
7- External 12 VDC power supply
BATT+
BATT-
NC NOC
8
Y
B
R
G
3
5
4
6
2
1
NC
NO
C
NC
NO
C
1
2
BATT+
BATT-
NC NOC
8
Y
B
G
3
5
4
2
1
+ -
7
6
R