Bosch DS7200V2-EXP - Area-Wide Parameters; Table 26: Account Number Addresses;Defaults; Table 27: Account Number Entry Selections

DS7200V2-EXP | Installation Guide | 3. Control Panel
Programming
EN | 65
Bosch Security Systems, Inc. | 04/12 | F01U253045-02
3.3 Area-Wide Parameters
The parameters in this section configure the control panel’s areas. Each area has 16 characters of
programmable text for an area name and 16 characters of programmable area idle text, which appear
on the text keypad display.
The DS7240V2 supports up to four areas. The DS7220V2 supports up to two areas.
All control panel text is programmed from the text keypad in a special text-programming mode. See
Text Entry Addresses on page 47 for text programming instructions.
Area # Account Number
• Address/Default: See Table 26
• Selections: 0 to 15 (see Table 27)
Table 26: Account Number Addresses/Defaults
Area
Account # for
Routing Destination
1
Account # for Routing
Destination 2
Default Account #
(for both
destinations)
1 Address 0276 to 0281 Address 0286 to 0291 10, 10, 10, 10, 0, 0
2
Address 0298 to 0303
Address 0308 to 0313
10, 10, 10, 10, 0, 0
3 (DS7240V2 only) Address 0320 to 0325 Address 0330 to 0335 10, 10, 10, 10, 0, 0
4 (DS7240V2 only) Address 0342 to 0347 Address 0352 to 0357 10, 10, 10, 10, 0, 0
Table 27: Account Number Entry Selections
For this
Selection
Press this
Key
For this
Selection
Press this Key
0 10 8 8
1 1 9 9
2 2 B 11
3 3 C 12
4 4 D 13
5 5 E 14
6 6 F 15
7 7 Terminate 0
Each area uses the account number entered here to report to the ARC receiver. Different account
numbers can be programmed for two routing destinations. See Routing Destinations on page 50 for a
complete description of how the control panel directs reports to the routing destinations.
Account numbers can contain up to six (6) digits. If less than four digits are entered, the control panel
adds zeros to the end to make a four-digit account number.
The control panel automatically truncates the account number to the maximum length supported by
that format. See Control Panel Events and Reporting Formats on page 108 for a complete description of
the reporting formats available to the control panel.
One account number digit occupies each address. Use a zero (0) to terminate the account number
entry if it is less than six digits in length.
For example, to set an account number of 1234, enter 1 2 3 4 0 (0 = Terminate).
Use “10” ([1][0] from the keypad) to enter “0.” Use “0” to terminate the account number.