DS7200V2-EXP | Installation Guide | 3. Control Panel
Programming
EN | 49
Bosch Security Systems, Inc. | 04/12 | F01U253045-02
3. Control Panel Programming
The contents of this section are organized as in Remote Programming Software (RPS).
This section only covers the available programming parameters when the control panel
enters Installer Programming Mode. The programming section in the DS7200V2 Expert
Programming Guide (P/N: 4998153891) covers all of the control panel’s programming
parameters.
This section contains programming parameter information pertaining to the DS7240V2 and DS7220V2
Control Panels. Settings for parameters are stored at one or more addresses. For an overview of how
to program the control panel from a DS7447E or DS7447V2 Text Keypad, see Keypad Programming on
page 45.
Numbers enclosed in braces (for example, {137}) that appear throughout this document refer to the
control panel’s event numbers. See Control Panel Events and Reporting Formats on page 108 for event
descriptions.
The default Installer PIN is 9876. The default PIN for User 1 is 1234. All other user PINs are not
programmed by default. See Installer PIN on page 69, and PIN, User # on page 71 for more information.
3.1 Understanding the Option Parameter Charts
The programming section of this document uses charts like the one below to identify the available
selections for option parameters.
Enter This Data Digit to Select Options
Do Not Wait for Dial Tone
“R” Function/Three-way Calling
Phone Line Fault Requires Reset
The first option usually disables or turns off all the other options.
The data digit values (labeled 0 to 15 under the “Enter This Data Digit to Select Options” heading) are
displayed across the top of the table. Each data digit is tied to options by a “.” To select an option,
enter the corresponding data digit value at the address programming prompt.
The option parameter’s default selection is listed above the table in bulleted form along with the
option’s address and selection range. The numbered cell that corresponds with the option’s default
setting is blackened to provide a quick visual reference. For example, the cell labeled “10” in the
example above is this option parameter’s default.
Columns that are grayed out are reserved settings and should not be selected.
To Next Page
Loading...
